DC1
Robot has to go 18 feet while going over a 3 inch gap not fall off the table.
1. State the assignment (problem/project) in your own words.
the challenge was to create a robot that goes 18 ft over a 3in gap and stops before it falls off the table
2. What are your input factors? (What do you need to know or do before you can begin?) Include the research you did.
i had to know how to use the program
3. Describe the process in detail. Explain the steps you followed in order to complete the project.
first we built the robot, then we programmed it to do the task above, then we tested it and it worked
4. Describe the final output / product in detail: (what are we looking at?)
the robot basically only has four wheels, its simple
5. Describe feedback you received during the project (suggestions, comments, etc). From peers, instructor ect.. How did you use this feedback to correct issues with your project?
we used the circumference of the wheels instead of time to get the robot to perform its task
6. What did you learn during the assignment such as tools, skills, design concepts, software, hardware, etc? ,
i learned everything, i didn't know how to use anything before jake showed me
7. If you were to do the project again, what would you do differently and why? Provide reasons and examples
i would have tried to get the robot to get as close as possible to the end of the table for a better grade
1. State the assignment (problem/project) in your own words.
the challenge was to create a robot that goes 18 ft over a 3in gap and stops before it falls off the table
2. What are your input factors? (What do you need to know or do before you can begin?) Include the research you did.
i had to know how to use the program
3. Describe the process in detail. Explain the steps you followed in order to complete the project.
first we built the robot, then we programmed it to do the task above, then we tested it and it worked
4. Describe the final output / product in detail: (what are we looking at?)
the robot basically only has four wheels, its simple
5. Describe feedback you received during the project (suggestions, comments, etc). From peers, instructor ect.. How did you use this feedback to correct issues with your project?
we used the circumference of the wheels instead of time to get the robot to perform its task
6. What did you learn during the assignment such as tools, skills, design concepts, software, hardware, etc? ,
i learned everything, i didn't know how to use anything before jake showed me
7. If you were to do the project again, what would you do differently and why? Provide reasons and examples
i would have tried to get the robot to get as close as possible to the end of the table for a better grade